Why HELLER HPAC10 restarts frequently?
The HELLER Air Conditioner might restart frequently due to several reasons: * Direct sunlight: Close the curtains. * Open windows or doors, many people in the room, or a heat source: Close doors and windows, remove the heat source. * Dirty filter: Clean or replace the filter(s). * Blocked air inlet or outlet: Remove the blockage.
What to do if HELLER HPAC10 Air Conditioner does not function?
If your HELLER Air Conditioner isn't functioning, here are a few things to check: * No power supply: Connect to a power supply outlet and switch it on. * “FL” flashes on the display screen: Drain water. * Timer-off is running: You can turn the unit on three minutes later.
What to do if compressor is not working in HELLER HPAC10?
If the compressor in your HELLER Air Conditioner isn't working, it might be due to the self-protection feature. Wait for 3 minutes and restart it again after the temperature decreases.
Specifies the correct placement for the portable air conditioner unit, including clearance requirements.
Details the parts and controls located on the front of the air conditioner unit.
Details the parts and connections located on the rear of the air conditioner unit.
Explains the functions of buttons and indicators on the unit's control panel.
Instructions for operating the unit in cooling mode, including temperature and fan speed settings.
Instructions for operating the unit solely as a fan, without cooling.
Details on using the automatic mode, which adjusts cooling based on room temperature.
Explanation of the sleep function for gradual temperature adjustment during operation.
Instructions for activating maximum cooling performance with high fan speed.
How to set the timer for automatic on/off operation of the air conditioner.
Guidance on cleaning the air conditioner housing and ensuring safe operation.
Instructions for cleaning and maintaining the air filter for optimal efficiency.
Steps for preparing the unit for storage at the end of the cooling season.
Operating Environment| permissible excessive operating pressure (suction) | 1.5 MPa |
|---|---|
| permissible excessive operating pressure (discharge) | 5.5 MPa |
| maximum allowable pressure (low pressure side) | 1.7 MPa |
| maximum allowable pressure (high pressure side) | 5.5 MPa |
Power| power supply | 220-240 V / 50 Hz |
|---|---|
| rated input (cooling) | 1050 W |
Performance| cooling capacity | 2.93 kW |
|---|---|
| air flow | 360 m3/h |
| noise | 55 dB(A) |
Refrigerant| refrigerant type | R410a |
|---|---|
| refrigerant charge | 500 g |
Weight and Dimensions| net weight | 25 kg |
|---|---|
| gross weight | 30 kg |
| dimensions (WxHxD) | 433 x 795 x 330 mm |
To Next Page
