• Always unplug the appliance before cleaning or changing any parts of the appliance, or when it’s
not in use.
• Never immerse the appliance in water or any other liquid.
• The appliance must not be used if the guards are not fastened according to instructions.
• Do not use your appliance with an extension cord unless it has been checked and tested by a
qualified electrician or electrical supplier.
• The air conditioning unit must always be stored and transported upright, otherwise you may
cause irreparable damage to the compressor; in case of doubt wait at least 24 hours before you
start the air-conditioning unit.
• Avoid restarting the air conditioning unit unless 4 minutes have passed, since being turned off,
or the compressor may get damaged.
• The plug should be well secured and not damaged.
• Do not plug in the appliance with an adaptor.
• Plug into the wall socket before switching on the appliance, and then press the ON/OFF button.
Special Recommendations
• Ensure that the appliance is positioned on a flat, large, dry surface without any obstacles nearby.
A minimum distance from furniture and walls is 50cm in all directions.
• The plug should be easily accessible.
• In order to maintain the function of the compressor, the appliance should always be in a vertical
position.
• Do not use the appliance near gas or other flammable liquids.
• Do not block the air outlet, inlet grills or the air inlet ventilation.
• Do not use spray (insecticides, paint) or any other flammable products near the appliance as the
plastic may become deformed. The unit may also sustain electrical damage.
Energy Saving Tips
• Keep blinds and /or draperies, on any windows, closed during the sunniest part of the day.
• Keep the filters clean. Under normal conditions, the filters should be cleaned every 2 weeks.
Since the filters remove airborne particles, more frequent cleaning may be necessary, depending
on the indoor air quality.
• Set the fan speed switch to high cool and the thermostat to the coolest position for the initial
start-up, then set the Fan switch to Low cool and lower the thermostat to a comfortable setting.
Suggestions
If you want to get better effect, we suggest you not to use cooling function when ambient environment
is higher than 35°C.
WARNING
If the supply power cord is damaged, the power cord must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
This product has not been designed for any uses other than those specified in this booklet.
SAVE THESE INSTRUCTIONS
To Next Page
Loading...
Need help?
General
