2. Press the < / WA/ V key until the camera icon is selected by red box;
3. Press 01<0 keyto enterinto sub-menu,then press A/ V keyto selectyourdesired
camera;
4.Press 0K@ keyenterinto sub-menu;PressA/ V keyto selectÅ+thenpress0K
key;
5. When the iconl displayed on the LCDscreen, pressthe PAIRbutton on the back of
camera;
6. Once paired,Successful pairingicon@ showsontheLCDscreen;
7. If fails, repeat the above steps.
8.1.2 DELETTING A CAMERA
1.Press the MENU@key andthe menuwill popup;
2. Press the < / WA/ V key until the camera icon is selected by red box;
3. Press 0K@key enter into sub-menu;then pressA/ V keyto selectyour desiredcamera;
4. Press 01<0 keyenter into sub-menu;PressA/ V keyto select then press0K key;
5. PressA/ V keyto select •
6. Press 0K@ keyto confirm;
7. Press the keyto Exit.
8.2 ALARM SETTING
You can use the alarm to remind yourself to feed your baby / change diaper / sleeping, etc.
1. Press the button and the menu bar will pop up.
2. Press the < / WA/ V key until the alarm icon
is selected by red box.
3. Press 01<0 keyenter into sub-menu,Pressthe < / Y/A/V key to selectedthe alarm
time you need;
4. Press 01<0 keyto confirm;
5. Press the keyto Exit.
Note 1: The minimum unit is 0.5 hour. The maximum setting is 5 hours (7 levels).
Note 2: Once the alarm is turned on, alarm icon will display on top of the screen.
Note 3: The alarm default setting is OFF.
Note 4: When the alarm is ringing, press any key on the parent unit to turn the alarm off.
Note 5: If you don't turn off the alarm, the alarm will ring for 1 minute. After three minutes
the alarm will ring again for 1 minute. The alarm will ring for three times in total, after this
the alarm goes off.
8.3 VOX SETTING
This mode allows you to control the sound activation of your baby unit. If there is no sound
around the baby unit within 30 seconds, it will stop audio transmission and turn off the
screen of the parent unit. When the baby unit detects any sounds louder than the sensitivity
level, it will start transmitting the signal to the parent unit again and turn on the screen of
the parent unit. To change the VOX level, please follow the below instructions.
1. Press the MENU key then the menu will pop up;
a isselectedbyredbox.
2. Press the < / WA/ V key until the VOX icon
3. Press 01<0 keyenterinto sub-menu,then pressA/ V keyto selectdesiredlevel;
To Next Page
Loading...
