9
360094-1/J
Operation
Overwrap bag
Overwrap bag MUST be used because:
1 It secures plasma bag to the basket
2 It protects plasma bag against water-borne contaminants
3 If plasma bag breaks, contents will not contaminate water bath.
NOTE: Use one overwrap of appropriate size per plasma bag.
Recommended:
► Use security snaps on smaller bags that tend to oat.
► Load plasma bags requiring same thaw time.
► In DH8 models: when loading 2 bags on same side of basket, place thicker bag in the front-most
compartment.
1 Insert bag into appropriate size overwrap.
2 On control panel, press LIFT OUT button to raise and open basket.
LIFT OUT button
3 (DH8 models) If loading a jumbo or wide bag, remove basket divider. Squeeze sides of the divider
together and pull divider away from basket.
Removing divider from DH8 basket.
4 Place overwrapped plasma bag in basket, hooking top overwrap slot around top basket tab. For large
overwraps, ensure both slots are hooked around the tabs.
5 Insert security snap through top set of holes of basket compartment. Push snap toward basket until it
snaps against overwrap bag.
Bag in standard-sized overwrap with security snap
To Next Page
Loading...
