Helmer QuickThaw DH2 - Draining the Chamber; Removing Baskets

11
360094-1/J
Operation
4.6 Drain chamber
!
CAUTION ► Turn off and disconnect power before draining.
► Do not move thawer if lled or when connected to power.
Thawer has a drain port with closed valve. Connect the coupling valve with drain tube to the port. If the
waste container or drain is not adjacent drain port, use 180 degree tting and U-tube to extend drain tube.
Left: Drain port with coupling valve and drain tube connected. Note release button at arrow.
Middle: Drain tube with coupling valve installed.
Right:U-tubewith180degreettinginstalled.
1 Turn off thawer. Disconnect from power.
2 Place open end of drain tube into waste container or drain.
3 Push coupling valve on closed end of drain tube into drain port until it clicks into place.
Water immediately starts to drain.
4 Release drain tube from port by pressing down on drain release button.
4.7 Remove baskets
!
CAUTION
If basket is not installed, DO NOT press LIFT OUT button.
Remove the nger knob holding basket to the lift-out arm, and lift basket out.
Basket installed on lift-out arm. Finger knob circled.