12
360094-1/J
QuickThaw™ Plasma Thawing System Operation Manual
5 Maintenance schedule
Maintenance tasks must be completed according to the following schedule.
NOTE
These are minimum requirements. See Service manual for parts, calibration,
alarm testing, and cleaning information.
Task
Frequency
Weekly Quarterly Annually As
needed
Clean the chamber and basket (DH2 models) or
baskets (DH4 and DH8 models).
Clean the exterior.
Clean the fan. (DH8 100 V models)
Lubricate moving parts.
Check temperature calibration for the temperature
controller readout. Change if necessary.
Test the high temperature alarm.
Check the bearings on each basket for wear and
replace them if necessary.
END OF MANUAl
To Previous Page
Loading...
