HELVAR 435 - Table of Contents

To Next Page

To Previous Page

iii

Contents

1. INTRODUCTION ................................................................................................................................. 1

1.1. DEVICE LIMITS AND COMPATIBILITY ...................................................................................... 2

1.2. DESCRIPTION OF THE UNIT .................................................................................................... 2

1.2.1. Front panel LEDs ................................................................................................................................... 3

1.2.2. Button and switches .............................................................................................................................. 3

1.3. SYSTEM OVERVIEW .................................................................................................................. 4

1.3.1. Helvar devices and DALI networks ....................................................................................................... 5

1.3.2. BACnet/IP network ................................................................................................................................ 5

2. CONFIGURATION ............................................................................................................................... 6

2.1. CONFIGURATION PAGES ......................................................................................................... 6

2.2. CONNECT TO THE 435 BACNET GATEWAY .............................................................................. 7

2.3. CONFIGURE THE COMMS INTERFACE .................................................................................... 7

2.3.1. Configure the IP config settings ............................................................................................................ 8

2.3.2. Configure the comms settings .............................................................................................................. 9

2.4. CONFIGURE THE MAP POINTS .............................................................................................. 10

2.4.1. Discover and select workgroups and devices..................................................................................... 11

2.4.2. Configure the mapping to BACnet object types .................................................................................. 12

2.4.3. Edit the BACnet table .......................................................................................................................... 14

2.5. BACKUP AND RESTORE SETTINGS ....................................................................................... 16

2.5.1. Create a backup ................................................................................................................................... 16

2.5.2. Restore: Backup configuration or change device firmware ............................................................... 17

2.6. CONFIGURE THE LOGIN SECURITY ....................................................................................... 17

3. ORDER CODES ................................................................................................................................. 19

4. PROTOCOL IMPLEMENTATION CONFORMANCE (PIC) STATEMENT .............................................. 20

ANNEX A – PROTOCOL IMPLEMENTATION CONFORMANCE STATEMENT (NORMATIVE) .................. 21