HENNESSY INDUSTRIES Coats 1250 User Manual

1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 615/641-7533 800/688-6359 www.ammcoats.com Manual Part No.: 8114307 03
HENNESSY INDUSTRIES INC. Manufacturer of AMMCO
®
, COATS
®
and BADA
®
Automotive Service Equipment and Tools. Revision: 06/06
®
READ these instructions before placing unit in
service KEEP these and other materials delivered
with the unit in a binder near the machine for
ease of reference by supervisors and operators.
See
Balancing Your
First Tire
on page 2.
1250 Wheel Balancer
Installation Instructions
Operating Instructions
Safety Instructions
Maintenance Instructions
 An Optional Feature

HENNESSY INDUSTRIES Coats 1250 Specifications

General

Model	Coats 1250
Type	Wheel Balancer
Wheel Width Range	1.5" - 20"
Max Wheel Width	20"
Wheel Diameter Range	10 - 24 inches
Power Supply	60 Hz

Summary

Important Safety Instructions

Safety and Hazard Definitions

Hazard Level Definitions

Explains signal words like DANGER, WARNING, CAUTION.

Safety Notices and Laser Precautions

General Safety Warnings

Laser Radiation Safety

Details laser radiation warnings and compliance information.

Principle Operating Parts and Controls

Power Switch and Offset Arm

Details the power switch and offset arm functions for operation.

Laser Guided Operation System

Explains the use of lasers for precise weight placement.

Setting Wheel Dimensions (DIM)

Wheel Data Entry Procedures

Control Panel Functions and Features

Panel Indicators and Options

Details weight display, mode LEDs, position indicators, and direct select options.

Balancing Modes and Techniques

Dynamic, Static, and EconoBalance Modes

Patch Weight Balance Procedure

Match Balance Optimization

Match Balance Procedure

Guides on optimizing tire-rim mating for reduced unbalance and better ride.

Troubleshooting and Diagnostics

Installation and Setup Guide

Electrical and Space Requirements