Hepha Trekking 7 - Before First Ride; Adjust the Handlebar; Adjust the Saddle Height

Before First Ride Before First Ride
9 10
loosen these two
screws and rotate the
display
STEP 1
STEP 3
STEP 5
STEP 1
Before First Ride
1. Adjust the handlebar
2. Adjust the saddle height
Hold the front wheel between your knees
to see if the angle between the handle-
bar and the front wheel is 90°. If not,
adjust the screws as shown on page 05
(adjust the stem).
Rotate the handlebar up and
down, adjust the handlebar to
your suitable position. Tighten
the four screws using the Allen
key #4.
STEP 2
Loosen the 2 screws shown in the
picture with an Allen key#5. You
can adjust the handlebars' angle to
the appropriate position suitable
for you. Then you can tighten the
screws to fix the angle.
STEP 4
Loosen the two screws using Allen
key #3, rotate the display holder up
and down to your comfortable
position, then tighten the screws.
Adjust the display holder
When properly adjusted, the saddle
should be at hip height, or check if your
knees form a 90° angle at the top of the
pedal motion, straightening out when
your foot reaches the bottom.
Rotate the grips up and down,
adjust the grips to your suitable
position. Tighten the screw using
the Allen key #3.