3. Check that everything is tight
5. Turn on/off the power
Check that all the screws or other tightening features are sufficiently tight, such as the
brake calipers, seatclamp, stem, levers, headset, derailleur, wheels and so on.
Install the display into the holder. Press the power button to turn on the power. Press and
hold the button for 2 seconds to turn off the power. Fully charge the battery of the ebike
before turning it on for the first time.
4. Charge the battery
Open the rubber cover and gently insert the charging plug into the charging port. When
fully charged, the indicator light on the charger will change from yellow to green. It will
take about 4 hours to charge the battery fully.
Unplug the charger after complete charging and close the rubber cover.
Follow these simple tips to keep your battery running in perfect condition for longer
- Only use the official Hepha battery charger.
- Charge the bike indoors, in a well-ventilated dry location (moisture and extreme
temperature fluctuations can affect the charging process).
- The bike will charge best at temperature between 10-40°C (50-104°F).
- Place the charger on a hard surface and make sure it is never covered. Never place
it on carpet or textile surface.
- Always keep the plug and connector free of dirt and moisture.
- Do not charge your bike if the charger or plug is damaged. If in doubt, contact
Hepha immediately.
- If you don't plan to use your bike for a long period of time, make sure the battery
gets a full charge cycle every six months.
STEP 2
Open the seatclamp on the seat
post, adjust the saddle height to
your suitable position and then
close the seatclamp to the right
position.
STEP 3
Make sure you don't exceed the
maximum saddle height indicated
on the seat post.
Before First Ride Before First Ride
1211
Your bike has activated the Bike
Lock Function by default set. That
means you can only unlock your
bike with the same display.
power botton
Charging port
Fully charge the battery
before your first ride.
To Next Page
Loading...