hergom SERE 70 - 2 - REMOVING THE FAN

2 - REMOVING THE FAN
ATTENTION! Before working on electrical parts
be sure the appliance has been disconnected
from the mains.
In order to replace the fans, observe the following
instrucons:
1. Remove the deector unit, the sides and the
boom secon. Pay aenon to vermiculite
parts; they can break. (Fig. 1)
FIG. 1
2. Loosen the 4 top screws that secure the fan
assembly and remove it from its housing by
pulling gently upwards. (Fig. 2 and Fig. 3).
FIG. 3
3. Disconnect the two terminals. Then loosen the
two boom screws holding the fan in place.
(Fig. 4).
4. Replace the damaged fan and install the fan
assembly by performing the above steps in
reverse order.
FIG. 4
FIG. 2