AGITATION MOTOR REPLACEMENT
The agitation paddles inside the Eureka canisters are operated by a 24 VDC motor
located on the bottom of each canister.
To remove and replace an agitation motor, please proceed as follows:
Disconnect the dispenser from its AC power source.
Remove the lower rear panel on the back of the dispenser.
Locate the appropriate canister and agitation motor and unplug the power connector
on the wiring harness to the motor.
Remove the two screws holding the motor assembly to the canister
and remove the motor.
Install the new motor ensuring that the drive bar on top of the motor
fits correctly into the slot on the bottom of the canister.
Secure the new motor with the two screws previously removed.
Plug the motor’s power connector into the wiring harness.
Restore power to the dispenser and test the new motor by initiating
an agitation cycle.
If the new motor works properly, replace the dispenser’s rear panel.
Ensure that the power cord and USB cable are not damaged or loose.
Mounting screws
Motor drive
bar
Agitation
motor
Drive bar slot
Power
connector
To Next Page
Loading...
