32
AIR CLEANER ELEMENT
The air cleaner element is viscous type, it
should be replaced at regular intervals
(page 26). Early replacement may be
required when riding in unusually wet or dusty
area.
î Remove the seat (page 19).
î Remove the side cover (1) by removing
side cover screws (2).
1
2
(1) Side cover (2) Side cover screws
î Remove the air cleaner cover screws/
washers (3) and the cover (4).
(3) Air cleaner cover screws/washers
(4) Air cleaner cover
4
3
î Remove the air cleaner element screws/
washers (5) and remove the element air
cleaner (6).
î Make sure that the spark plug gap is
0.8-0.9 mm using a wire-type feeler
gauge. If adjustment is necessary, bend the
side electrode carefully. Make sure the plug
washer is in good conditions.
î With the plug washer attached, thread the
spark plug in by hand to prevent cross-
threading.
î Tighten a new spark plug 1/2 turn with
after the plug seats, with a spark plug
wrench to compress the washer. If you are
reusing a plug, it should only take 1/8-
1/4 turn after the plug seats.
0.8-0.9 mm
To Next Page
Loading...
