HERO IGNITOR - FRONT BRAKE (Disc Type); Master Cylinder

If proper adjustment cannot be obtained by
this method, visit your Authorised Hero
MotoCorp workshop.
Location : Right handle bar.
FRONT BRAKE (Disc Type)
Recommended brake fluid : DOT 3 or
DOT 4
Master Cylinder (1)
Fluid level - Ensure that the brake fluid level
does not fall below "MIN'' mark (2) on front
brake master cylinder parallel to the ground.
The level decreases gradually due to piston
movement to compensate pad wear. If the
level decreases abruptly, check for the
leakages in the brake system and consult
your Authorised Hero MotoCorp
workshop.
Refer to the safety precautions on (page 38).
(1) Master Cylinder (2) "MIN" mark
NOTE : Clean the dirt and mud accumulation
between the brake pads (3) caliper (4) and the
disc (5) by using a water jet.
Always contact your Authorised Hero
MotoCorp workshop for refilling of
master cylinder when necessary. Do not
mix DOT 3 and DOT 4 brake fluid.
57