Stand-alone Operation using MD2 keypad
Time and Day setting
• Turn MD2 on.
• Press for 3 seconds until the minutes display flashes. Press or to change the
value (each press = 1 minute).
• Press the button again to change the hour display. Press or to change the
value (each press = 1 hour). This is a 24 hour clock.
• Press the button again to change the day. Press or to select the day (1-7 for
Monday – Sunday so e.g. Friday is 5).
Mode selection & settings
The MD2 has 3 temperature modes: Manual (Constant); Eco and Program modes.
• Press to select mode.
The Eco mode is displayed as a symbol (top left of display). Eco Mode is a lower-than-normal
temperature setting that you can apply to save energy (e.g. on holiday) or as a frost-protection setting. This
setting can also be manually overridden.
Program mode is displayed as (the number denotes which period of the day is active). Any manual
override in program mode remains in effect only until the next period.
Manual Mode is displayed as a symbol (top left of display). Manual mode allows you to set whatever
temperature you require and this will be maintained until you change it or until another mode is selected.
To Set Eco Mode Temperature:
In Eco mode, press and to set the desired setpoint temperature. The temperature will
flash while it is saved and then return to a steady display of current room temperature.
To select a mode at any time, press the button and choose your required mode. The selection will
override the program schedule or current temperature setpoint until another mode is selected.
To Next Page
Loading...
