16
Clutch only – pedal force
The procedure to adjust the clutch pedal force differs slightly
from the procedure to change throttle pedal force. Instead of
one slider you need to adjust two sliders.
In the moving front arm and in the rear (static) side arm of
the clutch pedal you’ll find two adjustments (sliders) which
mainly change the pedal force.
The adjustment is made as follows:
1. Loosen (do not remove) the nut on the adjustment sliders.
2. Slide the adjustment slider to the desired position.
3. You must move the entire assembly up or down, not only
the front or rear part of the assembly.
• For the lowest force, this means that the bolt in the front
arm is in the lowest position in the slot, while the rear bolt
is in the highest position in the slot.
• For the highest force, this means that the bolt in the front
arm is in the highest position in the slot, while the rear bolt
is in the lowest position in the slot.
• For a medium force, position both bolts in the middle.
For every setting you choose, both sliders must sit in the
opposite position in their relative slot.
4. Re-tighten the nut.
To Next Page
Loading...