HF Scientific MicroTSCM - Default Chapter; Table of Contents

21648 (07/09)
REV 2.4
Table of Contents
Section Page
Specifications ................................................................................................... 1
1.0 Overview........................................................................................................... 2
1.1 Unpacking and Inspection of the Instrument and Accessories .................... 2
2.0 Safety ................................................................................................................ 2
2.1 Symbols Used In the MicroTSCM........................................................ 2
3.0 Theory of Operation........................................................................................ 3
3.1 Treatment of Water for Clarification..................................................... 4
3.2 Charge Analysis .................................................................................... 5
4.0 Installation and Commissioning ................................................................... 6
4.1 Sample Point ........................................................................................ 6
4.2 Flow Rate .............................................................................................. 6
4.3 Sensor Mounting & Plumbing .............................................................. 7
4.4 Analyzer Mounting................................................................................ 8
4.5 Electrical Connections .......................................................................... 9
4.5.1 Power ........................................................................................ 9
4.5.2 Outputs – Voltage & Current .................................................. 9
4.5.3 Alarm Contacts........................................................................ 10
5.0 Operation ...................................................................................................... 11
5.1 The Sensor/Sampler ........................................................................... 11
5.2 The Analyzer ....................................................................................... 11
5.3 The Graphing Screen........................................................................... 12
5.4 Menus ................................................................................................. 13
6.0 Calibration .................................................................................................... 14
6.1 Calibration Procedures ....................................................................... 14
6.2 EEPROM Programming Correction ................................................... 14
7.0 Automatic Control......................................................................................... 15
7.1 Optimization of Treatment Process..................................................... 15
7.2 PI Control Overview ........................................................................... 15
7.3 PI Control Procedure........................................................................... 16
7.3.1 Process Band Calculation........................................................ 16
7.3.2 Entering the Control Parameters ............................................ 17
7.3.3 Manual Control ....................................................................... 17