English - 69 -
NOTE: When connecting
a device via the YPbPr or Side
AV input, you must use the
connection cables to enable
connection. See the illustrations
on the left side. | To enable
PC/YPbPr audio, you will need
to use the Back Audio inputs
with a YPbPr/PC audio cable
for audio connection. | If an
external device is connected via
the SCART socket, the TV will
automatically switch to AV mode.|
When receiving DTV channels
(Mpeg4 H.264) or while in Media
Browser mode, output will not
be available via the scart socket.
| When using the wall mounting
kit (available from third party
in the market, if not supplied),
we recommend that you plug
all your cables into the back of
the TV before mounting on the
wall. | Insert or remove the CI
module only when the TV is
SWITCHED OFF. You should
refer to the module instruction
manual for details of the settings.
| The USB input on the back of the
TV(USB 2.0) supports devices up
to 500mA. Connecting devices
that have current value above
500mA may damage your TV.
For the USB inputs on the side of
the TV(USB 3.0) this limit value
is 1A. | By connecting an HDMI
cable to your TV, you have to use
only a shielded HDMI cable to
guarantee a sucient immunity
against parasitic frequency
radiation. And make sure to use
a High-Speed HDMI cable that
can transmit high definition signals,
such as 4K contents, for trouble-
free transmission.
If you want to connect
a device to the TV,
make sure that both the TV
and the device are turned o
before making any connection.
After the connection is done,
you can turn on the units and
use them.
Connections
To Next Page
Loading...