To Next PageTo Next Page
Need help?Do you have a question about the HIBLOW HP Series and is the answer not in the manual?
General| Energy Efficiency | High |
|---|---|
| Brand | HIBLOW |
| Series | HP Series |
| Applications | aquaculture |
| Maintenance | Low |
| Category | Pond Pumps |
| Power Consumption | Varies by model |
| Max Flow Rate | Varies by model |
| Max Head | Varies by model |
| Voltage | Varies by model |
| Diaphragm Material | Rubber |
| Weight | Varies by model |
| Dimensions | Varies by model |
Detailed breakdown of pump components and their identification numbers.
Initial steps for disassembling the pump to access chamber blocks, including removing the sound absorber.
Procedure for detaching the frame cover by removing screws.
Step to disconnect the L-tube from the casing block.
Detaching the chamber block by unscrewing retaining screws.
Loosening and removing U-lock nuts securing the diaphragm mounting block.
Detaching the diaphragm mounting block from the actuating rod.
Instructions for removing and replacing the diaphragm from its base.
Attaching a new diaphragm and ring to the diaphragm base without gaps.
Guide on separating valve casings and removing old valves.
Installing new valves into the valve seat, ensuring correct orientation.
Trimming excess material from valve pulling parts after installation.
Reassembly steps for the chamber blocks, including rod alignment.
Placing the actuating rod into the machine body and securing mounting blocks.
Reattaching casing blocks with screws and securing the L-tube.
Procedure for replacing the safety pin and related components.
Inserting a new safety pin into the terminal side hole.
Securing the locking collar onto the terminal side.
Final checks for the safety pin mechanism and actuating rod alignment.
Reattaching the frame cover using screws.
Placing the sound absorber back into the upper housing.
Reinstalling the upper housing and filter components.
Disconnecting wires from electromagnets using nippers.
Unscrewing and removing the SP switch from its mounting.
Detaching the electromagnet by removing securing nuts with a box driver.
Mounting new electromagnets and tightening the nuts.
Reinstalling the SP switch, paying attention to lever direction.
Preparing and soldering wires to the electromagnet terminals.
Finalizing the electromagnet replacement procedure.
