Hiboy P7 - Installing the Headlight; Installing the Saddle

6. Installing The Headlight
9
7. Installing The Saddle
8
2. Tighten the screw with nut by using the installing tool.
3. Take out the hexagonal wrench and open-end wrench in the tool kit, adjust the headlight to the proper position, and then lock the screws.
1. Shown in Figure 1, insert the screw of the headlight into the headlight hole.
2. Push the saddle down, pull up or push down to adjust the height.
3. Check to make sure the saddle is fully inserted and adjust it accordingly.
1. Install the saddle according to the picture.
4. Lock the handle.
1
2
43
21
3
Nut
Headlight hole
Headlight
Hexagon wrench
Nut
Installing tool