Installation Guide
iCLASS™ Reader Models R10, R30, R40, RW300, RW400
An ASSA ABLOY Group company
ASSA ABLOY
_____________________________________________________________________________________________________
HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690
Web page - www.hidcorp.com e-mail – tech@hidcorp.com
iClass
™ Reader Installation Manual 6090-900 Rev 8 Page
3
of
3
Red/Yellow ***DTR (Not Used)
Drain **Shield Ground
•
Hold Input
– when asserted, this line either buffers a card
read or disables a card read until released, as configured.
* Optional Connections. ** Drain wire can be data return line when a separate power supply is used. *** Not used on R10, R30, R40
FCC WARNING:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
For proper regulatory compliance, the drain wire should not be connected to ground at the power supply
end of the cable. The reader is intended to be powered from a limited power source output of a previously certified power supply.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
To Previous Page
Loading...
Need help?
General
