Need help?Do you have a question about the Hifonics Titan TXi4008 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Frequency Response | 10Hz - 30kHz |
| THD | < 0.1% |
| S/N Ratio | >95dB |
| Input Sensitivity | 200mV - 6V |
| Crossover Type | Variable |
| Fuse Rating | 30A |
| Power Output (RMS) | 400W |
| Power Output (Peak) | 800W |
Key factors for a successful car stereo system, emphasizing design and execution.
Recommendations for mounting amplifiers horizontally for optimal heat dissipation.
Best practices for routing RCA and power/speaker cables to prevent noise.
Proper gauge wire selection and secure chassis ground connection for reliable operation.
The correct order for connecting audio, power, and ground leads to the amplifier.
A safe, step-by-step method for powering up the system for the first time.
Details capabilities like impedance handling, tri-mode, crossovers, and protection indicators.
Features and controls for TXi4008/TXi6008 models, including crossover and level adjustments.
Features and controls for TXi4408/TXi6408 models, including multi-channel mode selection.
Features and controls for TX17508/TXi1008D/TXi1508D mono models, including impedance and filtering.
Basic application for stereo full-range sound with 2-channel amplifiers.
How to use 2-channel amplifiers in a mono bridged configuration.
Configuring a 2-channel amp for highs and lows in a 2-way active system.
Using 4-channel amplifiers for discrete 4-channel full-range audio systems.
Leveraging mono bridging for 2 or 3-channel systems with 4-channel amplifiers.
Setting up a 2-way system with channels for highs and mono bass on a 4-channel amp.
Using front/rear outputs for bi-amplification with fade control for highs and bass.
Using the 1-channel A/B class amplifier for sub-bass duties in bi-amplification.
Connecting D-class mono amplifiers for subwoofer systems.
Instructions for wiring multiple subwoofers in parallel to mono amplifiers.
Comprehensive table comparing features across all Titan TXi series amplifier models.
Adjusting High Pass, Bass EQ, Low Pass, and Level controls for optimal performance.
Techniques for matching input sensitivities and balancing audio levels in active systems.
Adjusting Subsonic, Bass EQ, Low Pass, Phase, and Level for mono amplifiers.
Identifying faults indicated by the PROTECT LED and internal diagnostics.
Addressing amplifier overheating, low output power, and fuse blowing issues.
Troubleshooting hiss, white noise, and electrical interference in the audio system.
To Next Page