Need help?Do you have a question about the Hifonics TXi 3000 and is the answer not in the manual?
General| Brand | Hifonics |
|---|---|
| Model | TXi 3000 |
| Category | Car Amplifier |
| Language | English |
Guidance on choosing a mounting location for optimal air circulation and lead management.
Steps for securely mounting the amplifier using provided brackets and screws.
Instructions for connecting ground, remote turn-on, and +12V power supply wires.
Adjustable frequency controllers for High Pass (10Hz-1200Hz) and Low Pass (30Hz-150Hz).
Variable Bass Boost control offering up to +12dB boost at 45 Hz.
Description of RCA inputs for audio signal and RCA outputs for signal pass-through.
Explanation of Power (green) and Protect (red) LEDs for amplifier status.
Switch for selecting LP/BP, HP, or FULL range modes for various speaker setups.
Level Input control to match amplifier sensitivity with head unit output (0.2V-6V).
Port for connecting a remote controller for bass level adjustment.
Connecting speakers and RCA cables for a 2-channel stereo front or rear system.
Setting the X-Over switch for FULL or HIGH PASS modes based on speaker size.
Procedure to set the input level for optimal gain in a 2-channel stereo setup.
Recommended Bass Boost setting (0dB) and note on Bass Remote usage.
Connecting a subwoofer to the bridged terminals for mono operation.
Setting the X-Over switch to LP (LOW PASS) for subwoofer operation.
Procedure to set the input level for optimal gain in a mono bridged setup.
Guidance on Bass Boost usage and Bass Remote control for subwoofers.
Adjustable Low Pass (30Hz-150Hz) and Bass Boost controls for channels 3/4.
Adjustable High Pass (10Hz-1200Hz) and Level Input for channels 1/2.
RCA inputs for full range signal and RCA outputs for 4CH mono mix.
Power/Protect LEDs and terminal for remote bass control.
Selection of LP/BP, HP, or FULL modes for channels 3/4.
Input Mode (2CH/4CH/DUPE) and X-Over modes (HP/FULL) for channels 1/2.
Connecting speakers to all four channels for stereo front and rear systems.
Setting X-Over switch to FULL or HIGH PASS for front/rear speakers.
Procedure to set input sensitivity for all four channels.
Recommended Bass Boost setting (0dB) for channels 3/4.
Wiring two subwoofers to bridged CH1/2 and CH3/4 terminals.
Setting Input Mode to 2CH and X-Over CH3/4 to LP for subwoofer.
Setting X-Over CH1/2 to DUPE mode for front speakers.
Setting Level Input and Bass Boost for front speakers and subwoofers.
Connecting front speakers and subwoofer for a mixed stereo/mono setup.
Descriptions for X-Over CH1/2 and CH3/4 settings on page 19 and 20.
Setting input level and bass boost for both stereo and subwoofer channels.
Information on using the Bass Remote for subwoofer level control.
Checks for fuses, connections, and voltage issues when the system fails to power on.
Diagnosing and resolving noise, white noise, or no signal issues.
Troubleshooting reasons for the red LED (overheating, shorts, overload, damage).
Identifying and mitigating electrical interference and engine-related noises.
RMS/MAX power output for TXi 3000 and TXi 3400 at various impedances.
Damping Factor, Signal-to-Noise Ratio, Channel Separation, THD&N, Input Sensitivity.
Frequency ranges for XOver filters and Bass Boost, and impedance handling.
Fuse ratings and physical dimensions (width, height, length) for both models.
To Next Page