Hifonics Zeus Evolution ZXE2000 - Master;Slave Operation; Connection Diagrams

12
MASTER/SLAVE OPERATION
The MASTER/SLAVE Operation allows to link two identical ZXE2000/1 ampliers. The advantage of this func-
tion is, that the crossover section of amplier 2 will be bypassed and for both ampliers the same crossover
settings come into operation, which can be adjusted on the MASTER amplier. Then both ampliers work
together as one big monoblock. Please refer to section ”MASTER/SLAVE OPERATION / 2 x ZXE2000/1” on
page 13 and the gures 5a to 5c on page 37.
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) Power-/Protection-LED
(2) Connector for the included bass level remote controller
(3) LOW PASS controller
(4) BASS BOOST controller
(5) SUB SONIC controller
(6) PHASE SHIFT controller
(7) LEVEL INPUT controller
(8) LINE INPUT L/R
(9) Mono audio output (OUT MASTER), leading to an additional ZXE2000/1
Mono audio input (IN SLAVE), coming from an additional ZXE2000/1
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle’s battery
(5) External cable fuse for +12V power wire (not included in the scope of delivery)
(6) Turn on wire from the head unit or the electrical antenna
(7) Fuses
1-CHANNEL OPERATION MONO / 2 x SUBWOOFERS (FIG. 4)
If you want to run the amplier with the 2 line output channels from the head unit to drive two subwoofers, con-
nect the following setup:
(1) Bass level remote controller
(2) To the head unit, line output rear left or subwoofer output
(3) To the head unit, line output rear right or subwoofer output
(4) Subwoofer 1 (2 - 8 Ω)
(5) Subwoofer 2 (2 - 8 Ω)
1-CHANNEL OPERATION MONO / 1 x SUBWOOFER (FIG. 3)
If you want to run the amplier with the 2 line output channels from the head unit to drive a subwoofer, connect
the following setup:
(1) Bass level remote controller
(2) To the head unit, line output left or subwoofer output
(3) To the head unit, line output right or subwoofer output
(4) Subwoofer (1 - 8 Ω)
FIGURES (P. 34-38)