Hifonics ZX 5.1 User Manual

Unbalanced RCA inputs for audio signal, used for front/rear speakers and subwoofer.

Controls for input signal level adjustment, variable from 0.15V to 4V.

Enables or disables HPF/LPF controls for full-range or filtered operation.

Variable High Pass Filter from 30Hz to 1.2KHz for channels 1-4.

Variable Low Pass Filter for channel 5 from 20Hz to 220Hz.

Connects to IR sensor for remote control signal reception.

Connects to vehicle accessory +12V for power.

Connects to head unit for remote turn-on/off functionality.

Carries digital audio signals from sources like DVD players.

Allows analog video input and outputs signal to a monitor for OSD.

Selects between NTSC and PAL video input formats.

Accepts digital coaxial video signals into the amplifier.

Lists output power at different impedance levels for stereo and bridged modes.

Details frequency response, damping factor, S/N ratio, THD, and input controls.

Describes input selector, HPF/LPF controls, and crossover for channel 5.

Details unbalanced inputs and remote control connector types.

Specifies terminal types, fuse details, and amplifier dimensions.

Illustrates connecting for 4 stereo speakers and a mono subwoofer.

Illustrates connecting for a 6-channel setup with stereo, subwoofer, and center channels.

Lists and describes the functions of each button on the remote control.

Instructions for installing or replacing the remote control battery.

Controls input source (Optical, Coaxial, Aux) via OSD.

Selects audio modes (Stereo, Phantom, Surround) via OSD.

Controls audio muting and master volume via the OSD interface.

Displays decoding status and navigates setup, trim, and calibration menus.