High Tech Pet Power Pet - Installing Your Power Pet Door; Important Installation Notes

___________________________________________________________________________________________
8 www.hightechpet.com High Tech Pet Products, Inc.
INSTALLING YOUR POWER PET DOOR
This is the easy part. Install the POWER PET and Outside Frame as
shown below.
IMPORTANT INSTALLATION NOTES:
a) When installing the inside mounting screws, make sure they are
only moderately tight. Over tightening will cause your Power
Pet door housing to conform to any irregularities in the at-
ness of your door or wall and will cause the door panel to slow,
stick or malfunction. Just tighten the screws until they stop. That
1. Cut Hole (wall installation
s
will require framing)
2. Install Power Pet
door
Door
or
Wall
Inner Frame now comes pre-
attached to Power Pet door
OUTSIDE
INSIDE
3. Install Outer Frame
Framing Tunnel
You may purchase our
optional WALL
ADAPTER TUNNEL
Or build your own
See installation notes