HighLine Bale Pro CFR650 - Attach Driveline to PTO

Section 2 - Transporting the CFR 650
8. Attach driveline to PTO.
Note: Use the Category 6 drive line with the
Feed Chopper Option.
Shut off the tractor engine before
attaching PTO driveline.
Entanglement in the rotating
driveline can cause serious injury
or death.
The CFR 650 shall not be operated
without the driveline shields in
place.
- Shut off the tractor engine and
remove the key.
- Check that the driveline telescopes
easily and that the shields are in good
condition and rotate freely.
- Lift the tractor PTO shield.
- Support the driveline, pull back on the
yoke collar, align the splines by
rotating the CFR 650 driveline and
push the driveline into the tractor PTO
shaft until the collar snaps into place.
- Push and pull the yoke several times
to ensure the driveline is locked. Do
not pull on the collar as this will
release the lock.
- Lower the tractor & hitch PTO shields
into place.
- Fold down the PTO support holder (1).
- Failure to fold down the support
may result in damage to the
driveline.
Connect Driveline to PTO
201194C2
Page 2-5