HighLine Bale Pro CFR650 - Re-adjust Discharge Rate; Re-adjust Lower Deflector; Stop Feed Rollers for Next Bale

Section 4 - Operating the CFR 650
10. Re-adjust the discharge rate lever (if
needed).
- If the different rate of material
discharge is desired:
- Stop the tractor and remove the
key.
- Wait until all flail drum rotation has
stopped.
- Move the discharge rate lever
- Higher Number = more
material discharged
- Lower Number = less material
discharged
11. Re-adjust the level of the lower
discharge deflector (if needed).
- To increase the discharge height,
raise the door to the one of the upper
slots.
- Pull the lower handle and raise or
lower the door as required.
12. Stop the feed rollers before loading
another bale into the processor.
Re-Adjust Discharge Rate Lever (If needed)
214087-2
Re-Adjust Lower Deflector (If needed)
214087-2
Shut Down Flail Drum When Loading Tub
201219
Page 4-7