Section 5 - Maintaining the CFR 650
Tires
Note: It is recommended to have the tires
mounted by a tire technician.
- Check the condition of the tires.
- Mount the rim so that the air valve will
be facing outward when mounted on
the CFR 650.
- Place the cone side of the lug nut
against the wheel rim. Torque to 75 lb-
ft (101 Nm).
- Tire Pressure - Fill the tires to 24 psi
(165 Kpa).
- Transport speed for should not
exceed 25 mph (40 kmh).
- When replacing the tires, refer to the
Specification Section for the size and
type of tires.
Axles
Check That the Axle U-bolts are Tight.
- Torque the axle u-bolts (1) to 250 lb-ft
(339 Nm) to ensure the axles do not
slide out of the frame.
- Maximum axle extension is 14" (355
mm) from the main tube edge to the
inside face of the spindle plate.
Tires
215126
Check That Axle U-bolts Are Tight
212017C
Tire Mounting
107094CC
Page 5-6
To Next Page
