Need help?Do you have a question about the HighPoint RocketRAID 2680 and is the answer not in the manual?
General| Host Interface | PCIe 2.0 x8 |
|---|---|
| Device Type | RAID Controller |
| Max Devices Supported | 128 |
| Operating Systems Supported | Windows, Linux, FreeBSD, VMware |
| Data Transfer Rate | 6 Gbps per port |
| RAID Levels | 0, 1, 5, 10, 50, JBOD |
| Memory | 512MB DDR3 |
| Ports | 8 internal mini-SAS (SFF-8087) |
Configure hard disks as RAID arrays or single disks using the RR2680 BIOS utility.
Set the system BIOS boot sequence to prioritize CDROM, then floppy, then SCSI.
Create a bootable diskette with the RR2680 driver for FreeBSD installation.
Boot from the FreeBSD CD, load the RR2680 driver from diskette, and proceed with installation.
Copy the RR2680 driver module file to the FreeBSD kernel directory.
Load the driver module during boot to verify its functionality and see attached drives.
Modify loader.conf to ensure the RR2680 driver loads automatically on system startup.
To Next Page