Hikmicro HM-TM36-LG/S - Page 28

25
control.
0x03, Auto-switch open,
referred to timing mode and
temperature difference mode.
(Write Only)
0x36
0x7C
0x05
Duration of minutes, 2-byte
10 minutes by default, as 0x00
0x0A.
Shutter Auto-switch Time
Interval
0x0A
0x36
0x7C
0x0C
0x02 Vegnetting Collection
（Write Only）
Manual collection of uniform
object data
0x36
0x78
0x02
Data is one byte.
Valid range is 0 to 100, 50 by
default.
Brightness
0x32
0x36
0x78
0x03
Data is one byte.
Valid range is 0 to 100, 50 by
default.
Contrast
0x32
0x36
0x78
0x10
Data is two bytes.
Valid range is 0 to 100, 50 by
default.
DDE Detail Strength
0x32
0x36
0x78
0x15
Data is one byte.
Valid range is 0 to 100, 50 by
default.
DNR Spectral Level
0x32
0x36
0x78
0x16
Data is one byte.
Valid range is 0 to 100, 50 by
default.
DNR Temporal Level
0x32
0x36
0x78
0x1A
0x00 to disable the cursor,
0x0F to enable the cursor,
0x02 to move upwards the
cursor,
0x03 to move downwards the
cursor,
0x04 to move leftwards the
cursor,
0x05 to move rightwards the
cursor,
0x06 to place the cursor in the
center,
0x0D to add the cursor to dead
pixel list,
0x0E to delete the cursor to
dead pixel list,
0x2N to move N digits
upwards the cursor (N is 0x1 to
Manual DPC and Cursor
Control Switch
0x00