Hikmicro LYNX Series - Maintenance and Environment; Emergency Procedures

Thermal Monocular User Manual
26
● The built-in battery type is 18650, and the battery size should be 24 mm × 72 mm. The rated
voltage and capacity are 3.635 VDC/3350 mAh.
● For long-term storage of the battery, make sure it is fully charged every half year to ensure the
battery quality. Otherwise, damage may occur.
● Use the battery provided by qualified manufacturer. Refer to the product specification for
detailed battery requirements.
● CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
● Improper replacement of the battery with an incorrect type may defeat a safeguard (for
example, in the case of some lithium battery types).
● Do not dispose of the battery into fire or a hot oven, or mechanically crush or cut the battery,
which may result in an explosion.
● Do not leave the battery in an extremely high temperature surrounding
environment,
which may result in an explosion or the leakage of flammable liquid or gas.
● Do not subject the battery to extremely low air pressure, which may result in an explosion or
the leakage of flammable liquid or gas.
● Dispose of used batteries according to the instructions.
● Use the battery provided by qualified manufacturer. Refer to the product specification for
detailed battery requirements.
Maintenance
● If the product does not work properly, please contact your dealer or the nearest service center.
We shall not assume any responsibility for problems caused by unauthorized repair or
maintenance.
● Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
● If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the device may be impaired.
Using Environment
● Make sure the running environment meets the requirement of the device. The operating
temperature shall be -20 °C to 55 °C (-4 °F to 131 °F), and the operating humidity shall be 95% or
less.
● DO NOT expose the device to high electromagnetic radiation or dusty environments.
● DO NOT aim the lens at the sun or any other bright light.
Maintenance
● If the product does not work properly, please contact your dealer or the nearest service center.
We shall not assume any responsibility for problems caused by unauthorized repair or
maintenance.
● Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
● If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the device may be impaired.
Emergency
● If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the