want to route the cables on the surface of the ceiling. Refer to
Conduit Installation on the Side for side cable routing.
5. Attach the camera to the ceiling by aligning the holes of the back
box with the holes on the ceiling.
6. Secure the camera with the supplied screws as shown in Figure
2-3.
Secure the Camera Figure 2-3
7. Route the cables through the cable hole.
8. Connect the video output connector to the monitor. Connect the
power connector to the power supply.
9. Adjust the image and focus. Please refer to the section 2.3 for
more detailed information.
10. Install the inner black liner back to the camera.
11. Install the bubble back to the camera and secure it with screws
as shown in Figure 2-4.
To Next Page
Loading...
