Too far away from the door/Obstacle below camera
Recommended installation
2.4 Counting configuration
Configuration for single camera
Step 1. Select VCA Resource. It is necessary to select the VCA source as People Counting Mode.
Step 2. Rule Configuration:
1) Enter 【VCA】-【People Counting】, check “Enable People Counting”。
2) Select the calibration mode: Manual and Auto are selectable.
Manual Calibration Mode: Input the Lens height (the height from Entry/Exit area to the camera),
Tilt Angle and Heel Angle manually, then click “Calibrate”, A red detection area will automatically
To Next Page
Loading...
