Network Camera User Manual
84
2. Select the Camera No.
Video Tampering
3. Check Enable Video Tampering checkbox to enable the video tampering
detection.
4. Click Edit to edit the arming schedule for video tampering. The arming schedule
configuration is the same as the setting of the arming schedule for motion
detection. Refer to Task 2: Set the Arming Schedule for Motion Detection in
Section 9.1.1.
5. Check the checkbox to select the linkage method taken for the video tampering.
Please refer to Task 3: Set the Linkage Method for Motion Detection in Section
9.1.1.
6. Click Save to save the settings.
To Next Page
Loading...
