The sensor may be burned out by a laser beam, so
when any laser equipment is in using, make sure that
the surface of sensor will not be exposed to the laser
beam.
Do not place the camera in extremely hot, cold, dusty
or damp locations, and do not expose it to high
electromagnetic radiation.
To avoid heat accumulation, good ventilation is
required for operating environment.
Keep the camera away from liquid while in use.
While in delivery, the camera shall be packed in its
original packing, or packing of the same texture.
Mark Description
Table 0-1 Mark Description
Introduction
Product Features
The main features are as follows:
High performance CMOS sensor
Auto white balance
Auto electronic shutter
Auto gain control (AGC)
IR cut filter
3-axis adjustment
Note:
Type III camera is applicable for indoor only.
Overview
1.2.1 Type I Camera Overview
To Next Page
Loading...
Need help?
General
