Network Camera User Manual
125
6. Click Save to save the settings.
Handling Exception
The exception type can be HDD full, HDD error, network disconnected, IP address
conflicted and illegal login to the cameras.
Steps:
1. Enter the Exception Settings interface: Configuration > Event > Basic Event >
Exception.
2. Check the checkbox to set the actions taken for the Exception alarm. Refer to
Task 3: Set the Linkage Method for Motion Detection in Section 10.1.1.
3. Click Save to save the settings.
Configuring Flashing Alarm Light Output
Flashing Alarm Light Output Settings
Steps:
1. Enter the Flashing Alarm Light Output settings interface: Configuration >
To Next Page
Loading...
