User Manual of Network Mini PTZ Camera
© Hikvision
Or Configuration > Advanced Configuration > System > Time Settings
Figure 7-2 Time Settings
Configuring Time Synchronization by NTP Server
Steps:
(1) Check the radio button to enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions by NTP server.
It can be set from 1 to 10080 minutes.
Figure 7-3 Time Sync by NTP Server
(3) You can click the button to check whether the confguration is
succeeded.
If the PTZ camera is connected to a public network, you should use a NTP
server that has a time synchronization function, such as the server at the
National Time Center (IP Address: 210.72.145.44). If the PTZ camera is set in
a customized network, NTP software can be used to establish a NTP server
for time synchronization.
To Next Page
Loading...
