HIKVISION DS-2DF8C842IXS-AELW - Set Manual Compass; Set Auto Compass; Set Power off Memory; Set PTZ Priority

4.10.1 Set Manual Compass
Use a direcon indicang device to determine the North at the device locaon, and set the North
for the device.
Before You Start
Use a
direcon indicang device to determine the north at the device locaon.
Steps
1.
Select the PT Mode as Manual.
2.
Adjust the lt posion of the device to 0 by controling the up arrow and down arrow on the PTZ
panel.
3.
Adjust the pan
posion to show the live view of the north direcon by controling the le arrow
and right arrow on the PTZ panel.
4.
Click Set as North.
4.10.2 Set Auto Compass
For the device that has built-in e-compass, the compass can automacally tell the north direcon
for the device.
Before You Start
Electromagnec interference may aact the accuracy of the e-compass. Use manual compass if
electromagnec interference occurs in the device installaon environment.
Steps
1.
Select the PT Mode as Auto.
2.
Click Calibrate to synchronize the north of the device with that of the e-compass.
4.11 Set Power
O Memory
This funcon can resume the previous PTZ status of device aer it restarng from a power-o.
Steps
1.
Go to Conguraon → PTZ → Basic Sengs .
2.
Select Resume Time Point. When the device stays at one posion for the set resume me point
or more, the
posion is saved as a momory point. The device returns to the last memory point
when it restarts.
3.
Click Save.
4.12 Set PTZ Priority
The funcon can set the PTZ priority of dierent signals.
Network Speed Dome User Manual
33