Need help?Do you have a question about the HIKVISION DS-2DF8223I-AEL and is the answer not in the manual?
General| Type | IP security camera |
|---|---|
| PTZ control | Yes |
| Placement supported | Indoor & outdoor |
| Connectivity technology | Wired |
| Maximum operating distance | 1500 m |
| Form factor | Dome |
| Product color | Black, White |
| International Protection (IP) code | IP66 |
| Sensor type | CMOS |
| Optical sensor size | 1/1.8 \ |
| Total megapixels | 2 MP |
| Maximum resolution | 1920 x 1080 pixels |
| Supported video modes | 240p, 480p, 720p, 960p, 1080p |
| Video formats supported | H.264, M-JPEG, MPEG4 |
| Analog signal format system | NTSC, PAL |
| Pan range | 0 - 360 ° |
| Pan speed | 160 °/sec |
| White balance | ATW, Auto, Daylight, Indoor, Manual, Outdoor, Sodium lamp |
| Tilt angle range | -20 - 90 ° |
| Minimum illumination | 0.002 lx |
| Field of view (FOV) angle | 59.8 ° |
| Optical zoom | 16 x |
| Focal length range | - mm |
| Maximum aperture number | 3.4 |
| Signal-to-Noise Ratio (SNR) | 55 dB |
| Headphone outputs | 1 |
| Built-in HDD | - |
| Compatible memory cards | MicroSD (TransFlash), MicroSDHC, MicroSDXC |
| Maximum memory card size | 128 GB |
| DC output voltage | 24 |
| Power source type | PoE |
| Power consumption (typical) | 60 W |
| Operating temperature (T-T) | -40 - 65 °C |
| Operating relative humidity (H-H) | 0 - 90 % |
| Ethernet interface type | Fast Ethernet |
Weight and Dimensions| Length | 365.2 mm |
|---|---|
| Weight | 8000 g |
| Diameter | 266.6 mm |
Covers critical warnings and cautions to prevent injury, death, or equipment damage.
General guidance on installing and cabling speed domes, including different types.
Detailed steps for installing Type I, II, III, and IV speed domes.
Instructions for connecting network, video, alarm, audio, and power cables.
Procedures for connecting alarm input and output signals to the speed dome.
Covers power cable requirements and Power over Hi-PoE connections.
Details on components and steps for wall mounting speed domes.
Mandatory conditions and installation steps for in-ceiling mounting.
Steps and wiring procedures for general ceiling mounting.
Guidance on protecting the device from lightning and power surges.
Instructions for cleaning and maintaining the speed dome's protective bubble.
Details on connecting the speed dome using the RS485 communication bus.
Table of recommended wire gauges for 12VDC power based on distance.
Table of recommended wire gauges for 24VAC power based on distance.
Information on wire gauge standards and cross-sectional areas.
To Next Page