1.5 Power-up Action
After the power is applied, the camera will perform self-test actions. It begins with lens actions and
then pan and tilt movement. After the power-up self-test actions, the information shown in Figure 1-17
will be displayed on screen for 40 seconds.
The system information displayed on the screen includes the camera model, address, protocol, version
and other information. The COMMUNICATION refers to the baud rate, parity, data bit and stop bit of
the camera. e.g., “2400, N, 8, 1” indicates the camera is configured with the baud rate of 2400, no
parity, 8 data bits and 1 stop bit.
To Next Page
Loading...
