Firmware: when you select Firmware, you need to find the firmware in your computer to
upgrade the device.
Firmware Directory: You need to find the directory where the firmware locates. The device can
find the firmware in the directory automatically.
3. Click to select the local upgrade file and then click to start remote
upgrade.
Note:
The upgrading process will take 1 to 10 minutes. Do not disconnect the power of the camera during
the upgrading process. The camera reboots automatically after upgrading.
Figure 7-11 Remote Upgrade
7.2.2 Log Searching
Purpose:
The operation, alarm, exception and information of the camera can be stored in log files. You can also
export the log files on your demand.
Before you start:
Configure network storage for the camera or insert a memory card in the camera.
Steps:
1. Enter the Log interface:
Configuration >System > Maintenance > Log
Figure 7-12 Log Searching Interface
To Next Page
Loading...
