3.3 Modifying the IP Address
Purpose:
To view and configure the camera via LAN (Local Area Network),
you need to connect the network camera in the same subnet
with your PC. Then, install the SADP software or client software
to search and change the IP of network camera. We will take
modifying the IP Address via SADP software as an example to
introduce the IP address modification.
Steps:
1. Run the SADP software.
2. Select an active device.
Note:
Please refer to Chapter 3.2 to activate the camera if the
camera is inactive.
3. Change the device IP address to the same subnet with your
computer by either modifying the IP address manually or
checking the checkbox of Enable DHCP.
Modify the IP Address
To Next Page
Loading...
Need help?
General
