Steps:
(1) Check the radio button to enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions by NTP server. It can be
set from 1 to 10080 minutes.
Figure 7-58 Time Sync by NTP Server
You can click to make sure that the NTP server is connected.
If the speed dome is connected to a public network, you should use a NTP server that has a
time synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the speed dome is set in a customized network, NTP software can be used
to establish a NTP server for time synchronization.
Configuring Time Synchronization Manually
Steps:
(1) Check the Manual Time Sync radio button.
(2) Click to set the system time from the pop-up calendar.
(3) Click to save the settings.
You can also check the Sync with local time checkbox to synchronize the time of the speed
dome with the time of your computer.
Figure 7-59 Time Sync Manually
To Next Page
Loading...
Need help?
General
