Select the Time Zone
Purpose:
When the speed dome is taken to another time zone, you can use the Time Zone function to
adjust the time. The time will be adjusted according to the original time and the time difference
between the two time zones.
From the Time Zone dropdown menu as shown in Figure 7-60, select the Time Zone in which the
speed dome locates.
Figure 7-60 Time Zone Settings
Configuring DST (Daylight Saving Time)
Purpose:
If there is the habit of adjusting clocks forward in your country in certain time period of a year,
you can turn this function on. The time will be adjusted automatically when the Daylight Saving
Time (DST) comes.
Steps:
1. Enter the DST interface by Configuration > Advanced Configuration > System > DST
Figure 7-61 DST Settings
2. Check to enable the DST function.
3. Set the date of the DST period.
4. Click to save the settings.
Configuring RS-485
Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of the PTZ
parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS-485
To Next Page
Loading...
Need help?
General
