HIKVISION DS-3E0105P-E User Manual

Unmanaged PoE Switch/User Manual
7
With the grounding bar
Step 1: Connect one end of the grounding cable to the binding post on the grounding bar.
Step 2: Connect the other end of the grounding cable to the grounding terminal and fasten the
screw.
Note
Connect the grounding cable to the grounding system in the equipment room. Do not connect it
to a fire main or lightning rod.
Without the grounding bar
If there is no grounding bar but the grounding body can be buried, follow steps below:
Step 1: Bury a 0.5 m or longer angle steel or steel pipe into the earth.
Step 2: Weld one end of the grounding cable to the angle steel or steel pipe and protect the
welding point against corrosion (electroplating or coating).
Step 3: Connect the other end of the grounding cable to the grounding terminal.

HIKVISION DS-3E0105P-E Specifications

General

Cabling technology	10/100Base-T(X)
Networking standards	IEEE 802.3, IEEE 802.3af, IEEE 802.3at, IEEE 802.3u, IEEE 802.3x
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN (RJ-45) ports	5
Maximum data transfer rate	100 Mbit/s
Input voltage	51 V
Output current	1.25 A
Power supply included	Yes
Power consumption (max)	63 W
Surge protection voltage	4 kV
Power consumption (typical)	632 W
Number of power supply units	1
10G support	No
Switch type	Unmanaged
Stackable	-
Product color	Blue
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports type	Fast Ethernet (10/100)
Total Power over Ethernet (PoE) budget	58 W
Power over Ethernet (PoE) ports quantity	4
Power over Ethernet (PoE) power per port	15.4 W
MAC address table	1000 entries
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	93.3 mm
Width	132 mm
Height	27.6 mm
Weight	299 g