User Manual of DS-7000HI-S Series Net DVR
Page 25
Wiper control key: [WIPER/MENU];
Light control key: [LIGHT/F1];
Auxiliary device control key:[AUX/F2]
Adjust preset description
In PTZ control mode, press[REC/SHOT]key, and press the preset number (three numeric
keys), DVR will adjust the corresponding preset number. Repeat pressing[REC/SHOT]key, and
press the preset number, DVR will adjust that preset number.
When you exit PTZ control mode, the camera will stay at the current position.
Note: The PTZ preset number is set already. Please refer to PTZ menu for preset setup. V1.4
firmware can support 128 preset numbers at most.
Start/Stop auto in PTZ control mode
In PTZ control mode, press[PLAY/AUTO]key to start PTZ auto function.
Press[PLAY/AUTO]key again to stop.
When PTZ is in auto mode, if you exit PTZ control mode, PTZ will continue auto
function.You must enter PTZ control mode again, and press[PLAY/AUTO]key to stop.
Exit PTZ contrl mode
Press[ESC]or[ENTER]to exit and return preview mode.
To Next Page
Loading...
