HIKVISION DS-K1T343 Series - Page 126

Enable M1 Card
Enable M1 card and authencang by presenng M1 card is available.
M1 Card
Encrypon
M1 card encrypon can improve the security level of authencaon.
Sector
Enable the funcon and set the encrypon sector. By default, Sector 13 is encrypted. It is
recommended to encrypt sector 13.
Enable EM Card
Enable EM card and
authencang by presenng EM card is available.
Note
If the peripheral card reader supports presenng EM card, the funcon is also supported to
enable/disable the EM card funcon.
Enable DESFire Card
The device can read the data from DESFire card when enabling the DESFire card funcon.
DESFire Card Read Content
Aer enable the DESFire card content reading funcon, the device can read the DESFire card
content.
Set Card
Authencaon Parameters
Set the card reading content when authencate via card on the device.
Go to Conguraon → Access Control → Card Authencaon Sengs .
Select a card
authencaon mode and click Save.
Full Card No.
All card No. will be read.
Wiegand 26 (3 bytes)
The device will read card via Wiegand 26 protocol (read 3 bytes).
Wiegand 34 (4 bytes)
The device will read card via Wiegand 34 protocol (read 4 bytes).
DS-K1T343 Series Face Recognion Terminal User Manual
112