HIKVISION DS-K1T343 Series - 7.2 Communication Settings

7.2 Communicaon Sengs
You can set the wired network, the Wi-Fi parameter, the RS-485 parameters, the Wiegand
parameters, ISUP and access to Hik-Connect on the communicaon sengs page.
7.2.1 Set Wired Network Parameters
You can set the device wired network parameters, including the IP address, the subnet mask, the
gateway, and DNS parameters.
Steps
1.
Tap Comm.
(Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2.
On the
Communicaon Sengs page, tap Wired Network.
Figure 7-4 Wired Network Sengs
3.
Set IP Address, Subnet Mask, and Gateway.
-
Enable DHCP, and the system will assign IP address, subnet mask, and gateway
automacally.
-
Disable DHCP, and you should set the IP address, subnet mask, and gateway manually.
DS-K1T343 Series Face Recognion Terminal User Manual
30