HIKVISION DS-K1T343 Series - Chapter 8 Configure the Device via the Mobile Browser; 8.1 Login; 8.2 Search Event; 8.3 User Management

Note
●
If the combinaon authencaon of face and QR code is supported, and the QR code
shortcut key is disabled ( there is no QR code shortcut key icon in the authencaon page),
you can scan the QR code in the middle of the authencaon page to authencate.
●
You can select call type from Call Room, Call Center, and Call
Specied Room No.
Call Room
When you tap the call buon on the authencaon page, you should dial a room No. to
call.
Call Center
When you tap the call buon on the authencaon page, you can call the center directly.
Call Specied Room No.
You should set a room No. When you tap the call buon on the authencaon page, you
can call the
congured room directly without dialing.
Theme
You can set the theme of the prompt window on the authencaon page. You can select Theme
as Default/Simple. If select Simple, the live view of the
authencaon page will be disabled,
and in the meanwhile, the person's name, employee ID, face pictures will all be hidden.
Voice Sengs
You can enable/disable the voice prompt funcon and adjust the voice volume.
Note
You can set the voice volume between 0 and 10.
Time Sengs
Set the me zone, the device me and the DST.
Sleeping (s)
Set the device sleeping waing me (minute). When you are on the inial page and if you set
the sleeping me to 30 min, the device will sleep aer 30 min without any operaon.
Note
If you set the sleeping me to 0, the device will not enter sleeping mode.
Wait to Logout (s)
If there is no operaon within the congured me, the system will logout.
Select Language
Select the language according to actual needs.
Community No.
Set the device installed community No.
DS-K1T343 Series Face Recognion Terminal User Manual
48